|
- RadioShack Returns To U. S. . . . | RadioReference. com Forums
RadioShack Returns To U S As Product Brand Last August, the brand was relaunched in the U S as a product rather than a retail brand More than 400 RadioShack-branded products are now available not only on a new radioshack com e-commerce site but through several dozen retailers across the
- Pro-97 Display Problem - RadioReference. com Forums
Ok folks, up for everyone's consideration is a blank Pro-97 display The scanner had been put on a shelf for around two months (while I was out of the country), with batteries removed It had not been touched by anyone I put batteries in and the display is blank upon power up It scans
- Radio Shack 20-047 Driver - RadioReference. com Forums
I have both the RadioShack 20-147 (Orange) and the GRE (Blue) cables and they both installed just fine without needing to download drivers Same here Just finished a fresh clean install of Win10 on a new hard drive with all available updates including Founders update Plugged in both my old 20-147 cable and the GRE blue version
- Scanner Tales: Radio Shack Scanners; the good, the bad and the just . . .
Most RadioShack scanners were made by GRE over the years, but Uniden also made some now and again For the most part the Uniden-made RS radios were very similar to contemporary Uniden scanners, albeit with RS programming methods and labels First the good: The PRO2004 5 6 were the best of the best in their day
- Pro-82 (20-315) Comp Programing - RadioReference. com Forums
I bought the programing wire for the pro-82 scanner but it will not show on my computer Serial Connector mono connector The guy at radioshack said it was the right one and the manual says i can program from my computer Any ideas?
- Programming Software, FREE (Old Models) - RadioReference. com Forums
Radio Shack has a FREE software download for programming some older model scanners: PRO-76, PRO-79, PRO-89, PRO-2016, and PRO-2017 It's very basic, but
- Need program software for win 10 - RadioReference. com Forums
Good afternoon I have been looking for programming software that will work on Windows 10, for my older Radio Shack PR0-92, original, not A or B model, software ver 1 00 I ordered a Radio Shack GRE Whistler FTDI USB scanner programming cable, 20-546, which came with the additional, adapter
- Whistler and GRE RS USB Programming Cable DIY
I had a Pro-97 and Pro-164 with the RadioShack 20-047 USB cable This worked fine for these radios I then bought a used Whistler 1065 to log P25 traffic The 20-047 worked fine for programming, but when I dumped trunking data from the scanner to the PC, it would lock up the cable and scanner after about 10 minutes of use
|
|
|