|
- LCP slide wont reassemble - Ruger Forum
I can make mine really hard to reassemble if the barrel springs are in the correct spot but pushed ever so slightly to one side or the other Then as the slide is put on, the edge of the barrel feed ramp hits the front of the slide rails on the lower frame
- Yet another novice who cant reassemble a Mark II pistol
Howdy, all! As I said in my introductory post, I have acquired a Ruger Mark II Target pistol I got it cheap because its previous owner did not treat it well The rear of the receiver looks like he tried to tap it into place with a meat tenderizer, he had not relieved the Volquartsen rubber
- Mark II reassembly. - Ruger Forum
I forgot how much fun it was to reassemble a Mark II from a full disassembly It's been about 2 1 2 years of fairly heavy use since I had it completely apart to put in a Volquartsen accessorizing kit and extended magazine release There are a couple good YouTube videos that help immensely with
- Reassembly of Mark II - Ruger Forum
I have always had a problem getting the holes in the barrel-receiver and the frame to line up to install the mainspring housing bolt stop pin assy when assembling my Mark II To solve this problem I took a 5 16" drill bit ( 312" diameter) and cut about 2 5" of the shank off Smoothed the end
- Mini 14 Reassembly: Almost as difficult as the Mark I
Yep That bolt always gives me trouble trying to reassemble the Mini-14 I watched this video, and apparently I haven't been disassembling it far enough I don't remove the bolt lock side plate
- 10 22 reassembly . . . damn - Ruger Forum
From my experiences I knew Rugers were easy to breakdown and reassemble Wrong answer! That scared me for life Maybe some 30 years later I break down my Mk III 22 45 just for the practice Compared to that the 10 22 is a piece of cake I like to try and wait as long as I can to get the new and improved model
- 10 22 Reassembly Issue HELP - Ruger Forum
A friend of mine recently purchased a 10 22 and took it apart to polish the bolt While trying to reassemble it he ran into an issue with the bolt Once the bolt and trigger assembly are put back in, the bolt will not cycle all the way back Something causes it to bind Also, while apart the
- 10 22 Trigger Jobs, Assembly Details - Ruger Forum
The assembly and reassembly details for the trigger group itself are virtually identical for the stock Ruger 10 22 parts Unlike the two prior videos, Tony Kidd talks about the correct way to reinstall the hammer strut hammer spring assembly The hammer spring is retained on the strut by a notched washer and the notch in that washer should face up when reinstalling the assembly Apparently
|
|
|