- Mini 3 Pro - Replacing rear motor without opening a drone
Hello I need to replace both rear motors I don't want to disassembly whole drone, so I'm thinking about pulling out the motor from the arm, cut the wires and solder new motor I know this is possible, because I pulled my motor out, but I'm worried about antenna and it's signal wire, because
- Gimbal screws and replacing bracket on - DJI Mavic, Air Mini Drone . . .
I have put back together the entire gimbal already, and I would much rather superglue a plastic piece to the motor than fully disassembling the gimbal again and replacing the motor entirely I am also looking for replacement Philips 1 screws for the gimbal internals does anyone have the specs on the screws?
- Replacing MOSFET, what to look for | Electronics Forum (Circuits . . .
Hello forum, I'm replacing the MOSFETs in an Electronic Speed Control (ESC) for RC cars My problem is, I don't really know what to look for when choosing the new MOSFET The current rating of my MOSFETs are all higher than the old ones in the ESC I'm more interested in the gate charge
- Replacing vehicle alternator warning lamp with LED
I'm sure that this must have been done numerous times in the past, but I'm darned if I can find any definitive description of how to do it anywhere As the title suggests, I'm trying to figure out how to replace an alternator warning lamp with an LED There are a couple of issues it seems: many
- Motor or ESC board failure? How can I tell? - DJI Mavic, Air Mini . . .
Replacing the ESC board is the single toughest repair on a Mavic, but the OP shows that it can be done Just be careful with all tee ribbon cables, dont damage them, and also dont let solder or flux splatter on to adjoining components If that happens, you will get a short, and might never be able to identify it
- DJI Mavic, Air and Mini Drones - DJI Mavic, Air Mini Drone Community
Repair Service: Replacing the LR arm axis was honestly a relatively easy repair After replacing the arm, and powering up the gimbal does its vertical and horizontal tests, but the roll motor "snaps" to ~-45* offset and doesn't move The roll motor "buzzes" lightly and stays engaged, providing resistance to the touch
- DJI Mavic, Air and Mini Drones - DJI Mavic, Air Mini Drone Community
After replacing the mavic 3 classic vision sensor module with a new one It says “error sensor vision” and the drone does not take off Any suggestions? DJi
- Replacing automotive diodes | Electronics Forum (Circuits, Projects and . . .
You can try replacing it I'd use a 2A standard diode The leads and body look too fat for a simple 1N4001 to 1N4007 range Also, are you sure it's the problem? Is this the switch by the driver's left knee? To toggle the dome light from always-on to off to on-when-door is open? Or the door switch
|