- replacing an absolete component of converter | Electronics Forum . . .
The original part is an isolated, switched-mode converter; high efficiency The LM317 is a non-isolated, linear regulator, and not suitable for 48V input (A linear regulator with 48V input 15V output to a 2W load would be dissipating almost 4W of heat; it would need quite a large heatsink adding, making it overall far larger than the original device, as well as wasting a lot of energy
- Mini 3 Pro - Replacing rear motor without opening a drone
Hello I need to replace both rear motors I don't want to disassembly whole drone, so I'm thinking about pulling out the motor from the arm, cut the wires and solder new motor I know this is possible, because I pulled my motor out, but I'm worried about antenna and it's signal wire, because
- DJI Mavic, Air and Mini Drones - DJI Mavic, Air Mini Drone Community
After replacing the mavic 3 classic vision sensor module with a new one It says “error sensor vision” and the drone does not take off Any suggestions? DJi
- Definitive Technology Subwoofer repair | Electronics Forum (Circuits . . .
I have a Definitive Technology compact subwoofer that went belly-up and started buzzing constantly instead of producing any sound After research, I decide to try replacing the primary 6800uf 80v capacitors After replacing the caps, the behavior has changed, but not really for the better
- DJI Mavic, Air and Mini Drones - DJI Mavic, Air Mini Drone Community
replacing a prop is much cheaper than replacing a drone crashed due to flying with compromised props Excellent advice
- Replacing MOSFET, what to look for | Electronics Forum (Circuits . . .
Hello forum, I'm replacing the MOSFETs in an Electronic Speed Control (ESC) for RC cars My problem is, I don't really know what to look for when choosing the new MOSFET The current rating of my MOSFETs are all higher than the old ones in the ESC I'm more interested in the gate charge
- RC not connected to mobile device after replacing button board
RC not connected to mobile device after replacing button board Mick P Dec 13, 2024 M
- Gimbal screws and replacing bracket on - DJI Mavic, Air Mini Drone . . .
I have put back together the entire gimbal already, and I would much rather superglue a plastic piece to the motor than fully disassembling the gimbal again and replacing the motor entirely I am also looking for replacement Philips 1 screws for the gimbal internals does anyone have the specs on the screws?
|