|
- Replace downward sensors | DJI Mavic, Air Mini Drone Community
From memory of a M2Z (same drone body), be careful to NOT lose the rubber seals around the sensors, they are escape artists and hide well
- Replacing a ceiling fan pull switch | Electronics Forum (Circuits . . .
Hey all! I need to repair a ceiling fan It is a combined 5 bulb light fixture with a 3 speed fan There is one pull switch for the light and one for the fan The string coming out of the pull switch for the fan went off It went off inside the switch so the whole switch needs to be replaced
- DJI Mavic, Air and Mini Drones - DJI Mavic, Air Mini Drone Community
The posts about reflashing the software only needs to be done if replacing the motherboard, camera, or any of the 3 gimbal axis motors This can be done with the complicated Py-Serial method or go to Drone-hacks com where it is much easier, just takes longer And free
- DJI Mavic, Air and Mini Drones - DJI Mavic, Air Mini Drone Community
I was swapping motherboards between two of my Mini 3 Pros, and noticed that one of the 4x arm antenna connectors was damaged and would not reattach to the new motherboard I cut it off thinking I could re-solder an undamaged connector on it, but the wire was far too intricate and delicate to be
- Replacing MOSFET, what to look for | Electronics Forum (Circuits . . .
I'm replacing the MOSFETs in an Electronic Speed Control (ESC) for RC cars My problem is, I don't really know what to look for when choosing the new MOSFET The current rating of my MOSFETs are all higher than the old ones in the ESC I'm more interested in the gate charge ratings, to allow the same fall and rise times
- zener diode replacement - Electronics Forum (Circuits, Projects and . . .
I need to replace 1N5274B zener diode it is rated 130V Can I replace with other zener diode with 130V? is there any general rule to place zener diode?
- DJI Mavic, Air and Mini Drones - DJI Mavic, Air Mini Drone Community
Repair Service: Replacing the LR arm axis was honestly a relatively easy repair After replacing the arm, and powering up the gimbal does its vertical and horizontal tests, but the roll motor "snaps" to ~-45* offset and doesn't move The roll motor "buzzes" lightly and stays engaged, providing resistance to the touch
- Drone blade replacement - DJI Mavic, Air Mini Drone Community
Is it worth replacing the blades if they only have a few scraps and a minor nick or two? I have replacement blades and haven't noticed any issues with the used ones Didn't know if there were any justifiable reasons to replace blades that I wasn't aware of
|
|
|