- 1800 Brakes: Bleeding Brakes and Clutch, Pad Wear Indicator
2) Reservoir No 2 is the remote brake fluid reservoir, located knee-high, at the right-hand side of the bike, just above the rear brake pedal It is used to flush the lower bleeder valves located on either side of the front-wheel brake calipers and the rear-brake bleeder, located on the rear wheel, at the top of the rear-brake caliper
- Removing 1300 coolant hoses and bypassing heat flow in. . .
Vacuum pump to empty the coolant reservoir Return hose at pump removed, used county water to give it a good rinse After that I rinsed it with "Distilled" water, cranked it briefly I added concentrated prestone yellow jug 2 quarts and one quart distilled water Add fresh coolant in the recovery tank Vacuum pump to get the air bubbles out
- VTX 1300 coolant replacement - Honda VTX Forum
I just bought my bike and it has 25000 miles on it I do not know if the coolant has ever been replaced So,can I just remove the hose from the bottom of the radiator, let it drain, refill, circulate, remove, drain, etc, then put new coolant into the reservoir? Or do I need to take it to the
- Clutch Reservoir Leaking - Honda VTX Forum
Clutch Reservoir Leaking Jump to Latest 5 1K views 9 replies 8 participants last post by FISTer Oct 29, 2011 BonhommeVTX Discussion starter
- Engine Coolant Change. - Honda VTX Forum
#19 · May 31, 2009 coolant reservoir location fill procedure Coolant reservoir on my 1800 is in front of the back wheel I had to take the voltage regulator off to pull the reservoir out To fill the entire system, I left my gas tank on I put a few small blocks of wood wrapped in washcloths under it to keep it up off the frame about 3 inches
- Brake reservoir - Honda VTX Forum
Got a hole in the lower brake fluid reservoir by the rear brake pedal on an '06 VTX 1800 R Anyone know where I can get a replacement I'm in Pa a little south of Harrisburg if that helps any Thanks , riders
- Help with step by step: removing replacing coolant reservoir
When the bike is hot and the reservoir level is full, when on the side stand, coolant seems to be leaking in the top corner if the tank where it is curved and meets the bike
- Coolant Change - Honda VTX Forum
At my last coolant change I connected a vacuum pump to the hose going to the reservoir and pumped some air out of the system a few times The hoses collapsed some, released and added more coolant Repeated this a few times Added fresh coolant to the reservoir The burp was done with the vacuum pump
|