|
- 1800 Brakes: Bleeding Brakes and Clutch, Pad Wear Indicator
2) Reservoir No 2 is the remote brake fluid reservoir, located knee-high, at the right-hand side of the bike, just above the rear brake pedal It is used to flush the lower bleeder valves located on either side of the front-wheel brake calipers and the rear-brake bleeder, located on the rear wheel, at the top of the rear-brake caliper
- Brake reservoir - Honda VTX Forum
Got a hole in the lower brake fluid reservoir by the rear brake pedal on an '06 VTX 1800 R Anyone know where I can get a replacement I'm in Pa a little south of Harrisburg if that helps any Thanks , riders
- CBR1000RR Clutch Problems: No Pressure! - Honda VTX Forum
Sounds like he only replaced the fluid in the reservoir and didn't bleed the thing all the way through (from the bleeder on the clutch slave, down below) Have him turn the handlebars all the way to the right, so the clutch reservoir is as high and level as possible
- Removing 1300 coolant hoses and bypassing heat flow in. . .
Vacuum pump to empty the coolant reservoir Return hose at pump removed, used county water to give it a good rinse After that I rinsed it with "Distilled" water, cranked it briefly I added concentrated prestone yellow jug 2 quarts and one quart distilled water Add fresh coolant in the recovery tank Vacuum pump to get the air bubbles out
- VTX 1300 coolant replacement - Honda VTX Forum
I just bought my bike and it has 25000 miles on it I do not know if the coolant has ever been replaced So,can I just remove the hose from the bottom of the radiator, let it drain, refill, circulate, remove, drain, etc, then put new coolant into the reservoir? Or do I need to take it to the
- 1800 Rear Brake Issues - Honda VTX Forum
I know I do not need to bleed my car brakes unless I open the system or the reservoir gets to low and causes air to get in If there is an opening (loose fitting or cracked line), then fluid will leak out When I bled the rear brakes on the bike, the air came from the rear caliper and not from the front
- Compteur de vitesse | Honda VTX Forum
J'ai acheté un VTX 1800 C de 2003 C'est une super moto, et j'en suis très content Le seul problème est que je ne vois pas très bien le compteur de vitesse sur le guidon (il est un peu trop loin et trop petit) J'aimerais le remplacer par un Type R avec le compteur de vitesse sur le réservoir
- Flushing brake fluid - Help! - Honda VTX Forum
Make sure the brake fluid reservoir is full Pump the brake pedal until it is firm While holding a slight pressure on it, open the bleeder screw a little and the air will escape Continue to hold pressure on the brake pedal until you have tightened the bleeder screw You may have to do this procedure a couple of times until you have all the
|
|
|