|
- Best strategy for installing Schluter trim at the tile. . .
Install the Schluter trim first so it will be perfectly plumb and in the right place Then run your tile from it to the inside corner wall You are using a 1 2 1 2 break On 24" tile, I like to use 1 3 break, but it is a preference Start your tile with a full one, then a half one, etc The cut at the wall will be whatever it is
- Kerdi Microcement - DIY Home Improvement Forum
I’m working on a bathroom remodel For ease of execution I’m planning on using Schluter products for my shower pan, and we want to microcement our walls Has anybody applied a microcement (such as Surecrete) over Kerdiboard or Kerdi membrane, or know if this can be done? If not possible, I’m
- Budget Friendly Alternatives to Schluter Products?
Hi all, Looking for cheaper but widely available alternatives to Schluter Kerdi (shower waterproofing) and Ditra (floor decoupling) I’d prefer not to use cement board + RedGard Project details: Custom shower with a long bench and full-length niche (needs waterproofing) Rough in dimensions
- Schluter Kerdi membranes and thinset - DIY Home Improvement Forum
I have never used Schluter Kerdi membrane for waterproofing, but am reading up on it and have some puzzling questions When using Schluter Kerdi membranes, Schluter instructions stated: What type of thin-set mortar should I use when installing Schluter™-KERDI? The type of bonding mortar used
- Is This Dry Pack Too Dry For Membrane? - DIY Home Improvement Forum
With Schluter, you can extend the pre-shaped pan with dry pack and then apply membrane over top of it That is the waterproofing component The question now is if the dry pack appears stable enough to apply thinset and waterproofing membrane on top if it
- Which In Floor Heat System to Buy? - DIY Home Improvement Forum
I found Schluter info to be confusing and misleading I installed a dedicated 240v and the the contractor installed the 120 mat causing me to then replace the wire connection at my expense with the Schluter tech Toasty Toes overcharging me $900 for a new elec spice connection which took a total of 2 hours!
- Schluter drain problem - DIY Home Improvement Forum
I'm using a Schluter pre-sloped shower pan with a Schluter drain and when I dry fit the drain, the flange of the Schluter drain sits about 2 and 1 4 in above the subfloor It should sit when properly installed about 3 8 to a half inch above the subfloor I think my main problem is that I don't
- Schluter shower pan extension? - DIY Home Improvement Forum
Schluter Kerdi board 1 2" thick which will cover both right and back wall and the other two walls will be frameless glass The Schluter shower pan is about 1-1 4" thick at the other perimeter
|
|
|