|
- engine stalls when I come to a stop. not all the time or. . .
Stalling 3600 trouble free miles up until now Started out with the machine stalling out when coming to a stop I had an idea the one way bearing in the wet clutch was toast because engine braking wasnt working like it used to Changed out the one way Was still stalling coming to a stop after changing
- Problem stalling. | Yamaha Wolverine Forum
Problem stalling Jump to Latest 2 5K views 2 replies 3 participants last post by Geo Nov 7, 2023 Utah Jack Discussion starter
- Stalling - Yamaha Wolverine Forum
3600 trouble free miles up until now Started out with the machine stalling out when coming to a stop I had an idea the one way bearing in the wet clutch was toast because engine braking wasnt working like it used to Changed out the one way Was still stalling coming to a stop after changing
- 2020 X2 stalling problem | Yamaha Wolverine Forum
I am the second owner of a 2020 Wolverine X2 It only has 78 miles on it The unit starts up, runs for a little bit, and then stalls out The original owner had the same problem and took it back to the Yamaha dealer with only 30 miles on it Their tech tested the fuel pressure and said it
- Stalling out - Yamaha Wolverine Forum
I had similar symptoms stalling and then surging when it would run at idle Coming off idle was blubbery, but mid to WOT was fine Check Engine Light was on intermittently Turns out after much parts swap at dealer, it was the barometric pressure sensor This was only at 500 miles and still under warranty
- Runs rough, stalls, crank no start. | Yamaha Wolverine Forum
So the problem started with the engine starting than immediately stalling upon cold starts about two months ago Didn’t think much of it since I really don’t use the machine as much as I want and thought it was just the nature of the beast My machine would run, but very very rough, the
- Stalling issue - Yamaha Wolverine Forum
As for the stalling issue, Yamaha says; "This is common during the break in period even up to 20 hours The engine is tight and the units may occasionally stall till the engine frees up a little
- Stalling - Yamaha Wolverine Forum
Anyone else have a stalling issue after refueling, it does go away after awhile
|
|
|