|
- how to write and read external SRAM in stm32F103
Hello friends, I am doing a project around stm32f103, where i need to load the hex file from remote server using wifi module What i did is, my device had less RAM so i connected an external SRAM so that i can dump the incoming hex file (size =60k) directly to the external sram and than to SD card later to the flash
- Phase shifted pwm using stm32f103 | Forum for Electronics
I am trying to build a current fed push pull DC DC converter This requires two waveforms with duty cycle greater than 50% and phase difference of 180 dergrees I have attached pic I would like to know the possible ways of achieving this I have tried using output toggle option but that
- STM32f103 is not working Blink Led Project on Proteus simulation but . . .
My first stm project Blinky Led works on real Hardware (BluePill Board) ,BUt not working on Proteus Simulation Whats the wrong with I ?
- [SOLVED] - STM32f103 wont start | Forum for Electronics
Hello, I designed a simple board based on STM32F103 and produce some of them and all of them work fine In my new design I use PB4 and PA8 pins but other parts of my circuit is the same as the old one However, the old program doesn't work properly( I can program my MCU correctly (it verifies my
- Pull-up and pull-down technology in microcontrollers
Hello everyone, I am making measurements for the characterization of pull-up and pull-down resistances in microcontrollers GPIO interface I am currently working on a STM32 microcontroller, and in particular the STM32F103C8T6 A ST Microelectronics employee on the ST Microelectronics forum told
- SWD in STM32 when SWD is configured as GPIO.
I do have a a couple of question regarding the SWD in STM32 : - How do I program the STM32 when I configure SWDIO and SWCLK into GPIO ? - Why when I have SWDIO and SWCLK and I send code from CubeIDE into STM32 the MCU is set into RESET mode ? It happens in my Nucleo and in my Custom board that
- [SOLVED] - STM32 bootloader Driver windows10 | Forum for Electronics
I was trying to connect the STM32F105RBT6 board with PC But the USB driver not found Tried different drivers from the internet, but no one actually works It says already updated driver installed Do you have any idea to find a perfect driver? Thanks in Advance
- [ARM] - Build a . hex file which including the Bootloader [STM32F]
I am working on an application based on STM32F103 chips After building the application, I do full chip erase using ST-LINK Utility and then flash the chip using new hex file I know that STM32 starts executing the code at the address of 0x8000000 However, my main program starts from address
|
|
|