|
- 6. 10. Washer Requirements | American Institute of Steel Construction - AISC
6 10 Washer Requirements 6 10 1 When are beveled washers required? 6 10 2 Why must washers completely cover the hole in the outer ply of slotted connections? 6 10 3 Why are plate washers required over long-slotted holes?
- anchor rod holes in base plates | Eng-Tips
table 14-1 in AISC 16th edition (recommended sizes for washers and anchor rod holes in base plates) specs the maximum hole diameters as long as special washers are used, like square washers or round washers that meet the acceptable width in the same table
- Common RFI #4: Provide Washer Plate Sizes Required at Anchor Rods and . . .
Plate washer sizes required for high-strength fasteners can be found in AISC RCSC Specification Table 6 1 and AISC 13 th Edition Table 7-15 Plate washer sizes should be provided for each anchor rod or fastener diameter
- AISC Important Tables | PDF | Building Engineering | Metalworking - Scribd
The document provides tables from the American Institute of Steel Construction (AISC) specifying standard hole sizes, bolt diameters, plate washer sizes, and bolt gage requirements for various steel connections It includes tables for angles, wide flange beams, channels, and anchor bolts
- Square Plate Washers - Portland Bolt
Square plate washers are made from low carbon steel and have a larger surface area than round washers Stock sizes are available for bolts from 1 2" to 1", with thickness of 195" up to 395"
- Pull-Through Testing of Plate Washers for Column Anchor Rod . . . - AISC
The enclosed report presents the results from the laboratory tensile testing of the anchor rod and nut, plate washer and base plate assembly, specifically with regard to the performance of the plate washers in the pull-through failure condition
- Washer Dimensions per AISC 13th edition | Eng-Tips
Table 14-2 of the AISC steel construction manual, 13th edition recommends an O D of 2-1 2" with a maximum hole diameter of 1-9 16" and a minimum thickness of 5 16"
- Table 6. 1 - Washer Requirements | PDF | Screw | Washer (Hardware) - Scribd
This document provides requirements for washer types and thicknesses required for bolted joints with oversized and slotted holes based on bolt diameter and material
|
|
|