- Anyone getting good accuracy out of TAC in 223? - AR15. COM
So far, TAC has been pretty atrocious in my WOA 20" Predator barrel MP518 (Staball Match) routinely gets me under 1", but TAC has been more like 1 5-2 5" groups Before writing off TAC altogether: Is it more accurate at lower velocities? Most of my loads have been pretty hot, but maybe it likes running a little slower? I've tried 77 69 52 SMKs, 77gr Barnes Matchburners, 75gr Hornady BTHP, and
- Experimenting with TAC in 5. 56 (based off StaBall thread) - AR15. COM
My best results with TAC has been with CCI 450 primers (an old Western Powder Manual spec'd with load data at the time) Rem 7 5 works too
- 69gr TMK with Ramshot TAC. . . anyone had any luck? - AR15. COM
Had good luck running 23 5 grs of tac with 69gr noslers set to 2 250 will shoot moa
- Lets see some 223 556 favorite loads using Ramshot TAC powder . . .
Firearm Discussion and Resources from AR-15, AK-47, Handguns and more! Buy, Sell, and Trade your Firearms and Gear
- Ramshot Tac and . 223 gt; Reloading gt; AR15. COM
I've used TAC, mostly with Sierra and Hornady bullets in the 65-75 grain range in Colt 1 in 7" barrels Flows well through a measure and generally provides good accuracy, but I've usually found H4895 will make at least slightly more accurate loads
- Has Remington TAC-13 been discontinued? - AR15. COM
Firearm Discussion and Resources from AR-15, AK-47, Handguns and more! Buy, Sell, and Trade your Firearms and Gear
- TAC load data for . 223 and 5. 56 from the source - AR15. COM
My plinking load for 55 gr pills out of a 16" 1 in 7 twist is 25 3 gr TAC and a CCI 400 which chronos at 2700fps The initial Ramshot data placed this load as a MAX load which it obviously wasn't 25 3 grains is just barely above the start load in the new data but then again these new specs are for an M-193 power load not a plinking load
- 300 blackout Barnes tac tx 120gr gt; Reloading gt; AR15. COM
Firearm Discussion and Resources from AR-15, AK-47, Handguns and more! Buy, Sell, and Trade your Firearms and Gear
|