|
- Replacing PCM ECM - Jeep Enthusiast Forums
If someone replaces the PCM ECM what has to be done? Does it need to go to the dealer for programming or anything I am posting this for a guy on militaryjeepers com Thanks to all who reply
- Disable the SKIM (Sentry Key Immobilizer Module) - Jeep Enthusiast Forums
Does anyone know how to do this? I want to be able to get new keys without having to pay $120 for the transponder grey ones
- Bent front lower control arm bracket. . . . how to bend it back
I would say best way would be to take it loose and then bend the bracket back and check the welds for cracks I welded in plates that tied the two ears together and to the tube I had the same thing happen to my last TJ
- CPS Crank Position Sensor failing? - Jeep Enthusiast Forums
CPS would seem to be the main suspect The most likely cause of it cranks and cranks but won't start up is the Crankshaft Position Sensor (CPS) located on the transmission bell housing Often this part is also referred to as the CranKshaft Position Sensor (CKP) CPS CKP failure is very common The CPS CKP can stop working with no warning or symptoms and the engine will not run or the engine
- All Jeep Factory Wheels- Names And Pictures
Canyon Factory Availability: TJ, TJ Sahara, ZJ Bolt Pattern: 5x4 5 Notes: ZJ canyons did not say "Jeep" on the center cap TJ canyons read "Jeep" on the center cap and include wider spokes and a deeper inside measurement on the front In the image the top wheels are ZJ canyons and the bottom wheels are TJ canyons
- TJ: Driver door limiting strap hook broke off, PICS
So yesterday I had just got to work, it was a little windy, opened my door and the wind took it, I tried to grab it but wasn't quick enough, the limiting strap didnt break, but the head of the bolt on the hook that secures the limiting strap to the door broke off Also the plastic piece on the
- Remove Skim Permanently!!!! For Real!! | Jeep Enthusiast Forums
I started with an 02 wj that would start and dies 3 secs later solid sentry key light on dash Did some investigating and found out thanks mostly to people on here that i had a skim issue and either my skim, pcm, or both were bad rather than replace all that with factory parts at god knows how
- FAQ - Coil spring measurements | Jeep Enthusiast Forums
Below are the approximate heights of various TJ coil springs when sitting at ride height with the weight of the Jeep on them The measurements are from the very top of the spring where it meets the isolator or coil bucket to the very bottom of the spring (again where it meets the isolator or
|
|
|