|
- Ten TJ Steering Upgrades compared - Jeep Enthusiast Forums
The July 2013 Jp magazine issue compares 13 different steering upgrades, and 10 out of 13 have TJ applications The online article
- Blower Motor Resistor Install - Jeep Enthusiast Forums
Once again, you don't even have to open the glove box for this install, the resistor for the TJ is BELOW the glove box Once those bolts are removed, slide the cover to the right to directly expose the blower motor resistor First remove the Red Clamp from the wire harness
- Best V-8 for TJ engine swap - Jeep Enthusiast Forums
For some time now I've been thinking of swapping in a V-8 engine in place of my 4 0L power plant What is the most desirable and most straight-foward engine to swap in? I've seen several posts for the Chevy LT1 engines, but is this really the best deal? The initial purchase price seems rather
- What are the must have upgrades for a TJ? - Jeep Enthusiast Forums
Ok so i stole this from the Zj thread but hey thought it was a good questions so here it goes What do you all think are the most important things to first address when looking to upgrade a stock TJ Things that will have the best benefit for the least money :confused:
- TJ Wrangler Technical Forum - Jeep Enthusiast Forums
Third generation of the classic Jeep - manufactured from 1997 till 2006 Known by the coil springs and round headlights Includes the Rubicon and Unlimited editions as well
- TJ Wrangler - Jeep Enthusiast Forums
TJ Wrangler2005 LJ - Just started her up after two years on trickle charge - all sorts of problems Could use some help
- FAQ - Coil spring measurements | Jeep Enthusiast Forums
Below are the approximate heights of various TJ coil springs when sitting at ride height with the weight of the Jeep on them The measurements are from the very top of the spring where it meets the isolator or coil bucket to the very bottom of the spring (again where it meets the isolator or
- Freon capacity? | Jeep Enthusiast Forums
I gotta have my a c system suctioned and recharged when I get done with my heater core The local shop charges about 33 bucks a pound How much should it need?
|
|
|