|
- Best V-8 for TJ engine swap - Jeep Enthusiast Forums
For some time now I've been thinking of swapping in a V-8 engine in place of my 4 0L power plant What is the most desirable and most straight-foward engine to swap in? I've seen several posts for the Chevy LT1 engines, but is this really the best deal? The initial purchase price seems rather
- Remove Skim Permanently!!!! For Real!! | Jeep Enthusiast Forums
I started with an 02 wj that would start and dies 3 secs later solid sentry key light on dash Did some investigating and found out thanks mostly to people on here that i had a skim issue and either my skim, pcm, or both were bad rather than replace all that with factory parts at god knows how
- Best and correct method to reset ECM? - Jeep Enthusiast Forums
I've read disconnect battery cables and touch for 10 minutes, disconnect neg cable and turn key on off 3 times and disconnect battery cables and leave lights on for 10 minutes Which one or better method? Or do they all work equally well? mm
- FAQ - Coil spring measurements | Jeep Enthusiast Forums
Below are the approximate heights of various TJ coil springs when sitting at ride height with the weight of the Jeep on them The measurements are from the very top of the spring where it meets the isolator or coil bucket to the very bottom of the spring (again where it meets the isolator or
- Disable the SKIM (Sentry Key Immobilizer Module) - Jeep Enthusiast Forums
Does anyone know how to do this? I want to be able to get new keys without having to pay $120 for the transponder grey ones
- TJ 4. 0 Bogging and lack of power, Solution Found
I have just purchased my TJ and found from the get go it was down on power and would not pull very well over 3500RPM On reading the very helpful forum I began the process of elimination New Plugs, new leads and a new cap, I went for a short drive to find I had not fixed the problem Back on
- Jeep TJ Frame CAD Model - Jeep Enthusiast Forums
I've been working on a CAD model of the TJs frame based on the blueprints that are out there I'm doing this mainly for myself so its not full professional work but I do work as a CAD designer I used every available dimension on the 2D prints but there were a few places i had to estimate
- tj exhaust pipe size? - Jeep Enthusiast Forums
does anyone know the factory size exhuast pipes on a tj i need to put a muffler on my tj and im looking to order a muffler from summit but i dont know what size pipe it is and im deployed at the time being so i cant measure the pipe i checked the tj spec page and couldnt find anything i like the
|
|
|