|
- How much fluid for a TH-400 - Team Chevelle
Here is an easy one My tranny gasket was about gone so I replaced it I dropped the pan, changed the filter and gasket and then replaced the pan I put four qaurts Dextron Mercron III tranny fluid into it Started motor, let it get hot, shifted through all gears and checked the fluid level
- Pulling engine, with or without transmission attached
This allows me to lower the car back down after the engine tranny is out most of the way and gives needed clearance over the front of the car It really helps to have a couple of buddies to help
- Transmission cooler?? | Team Chevelle
I have a '67 Chevelle Coupe I am running a 350 with about 375 HP I am getting ready to install a new TH350 tranny and 2200 stall torque converter I plan up upgrading the stock radiator to an aluminum aftermarket (like Be Cool or Griffin) Do I need a trans cooler? If so, where do you
- Need Expert Tranny Help---TH400 Slipping In Drive - Team Chevelle
Need Expert Tranny Help---TH400 Slipping In Drive Jump to Latest 18K views 22 replies 4 participants last post by slingslingbinks May 9, 2011 T
- 700R-4 leaks after sitting, but only after a few days. . . . help
This tranny is about 1 1 2 years old and probably doesn't have 1500 miles on the rebuild It is an '89 model I had it completely gone thru with the typical extra clutch packs, Corvette servo, new reaction shield (?) and a Transgo shift kit, etc etc It was built by the highest regarded
- Th350 400 mount interchange? - Team Chevelle
All tranny tail housings should have 2 threaded holes (7 16 coarse thread) for attaching the rubber mount to the tail housing All 72-earlier tranny CROSS MEMBERS have 2 holes for 2 bolts to pass through and screw into a rubber mount with 2 threaded holes (7 16 coarse thread)
- Muncie trans leaking - Team Chevelle
Hello everyone, a few years ago I had a local guy rebuild my trans I guess he didn’t do a good job because it’s leaking in multiple spots The trans doesn’t seem that crazy to work on I have never opened one up though I’m a pretty mechanical educated guy I just never worked on a trans
- Decode tranny - Team Chevelle
Hi, could someone help out with the numbers from a 350 tranny I'm just trying to find out what year it is for future reference On the outside on both sides is 3T On the inside, on the rear cover is GM1, over about 2" is G12, and just below that is 6260233 I find no other numbers on the
|
|
|