|
- Uni-strut and clamps used as fire sprinkler pipe hangers
WE are seeing more and more cases of unistrut type systems fastening sprinkler piping to building structure If oriented so that piping is not hanging down against the clamp, the shear or slip load limits are small enough so that the piping does not meet the 5X weight of water-filled pipe + 250
- Unistrut Yield Strength | Eng-Tips
Unistrut reported to me that their Unistrut steel is 33 ksi steel that has been cold rolled to 42 ksi Does that happen because of compression during the cold rolling process? If not, how, then is 33 ksi steel converted to 42 ksi? Therefore, can i use Fy = 42 ksi? I realize i can contact
- Strength of unistrut section | Eng-Tips
I been trying to figure out the strength of a channel shape unistrut bar bolted on a rolling load table, which will be subjected to a concentrated load applied through a ball screw Would some one help me get through this?
- Unistrut Weld Detail | Eng-Tips
What do you guys think about this detail? The legs of the unistrut are facing downwards The load is only about 150bs The existing unistruts are already welded in this manner so I am trying to match them I could add some small clip angles, if needed
- NFPA #13, Trapeze Hangers Unistrut. | Eng-Tips
I would also note that unistrut (generic) is NOT listed in any NFPA "tables" So while you see NFPA 13 showing examples of how to determine the section moduls for and angle iron trapeze member, what you are overlooking is what are the limitations of the "table" All I am saying is be careful, think about what you are doing
- Unistrut P1000 (or other) esr report | Eng-Tips
I'm working on a project in Anaheim, CA involving cable trays and unistruts My boss, the structural principal at our firm, recently mentioned that we should mention the evaluation report since it's in California Well, this put a monkey wrench in everything I was doing Not only has this
- Building a three tier brew stand with Unistrut - Homebrew Talk
I could use Unistrut Product Group or Unistrut Product Group I planned on a three tier verticle tower with square frames off of the main pole for three burners it seems simple but wanted to get some ideas as to one parts to use They are plenty strong and have some nice fittings to make a frame with out any welding any thoughts?
- Connecting threaded rod to Z-purlins? | Eng-Tips
We have some threaded rods we need to hang from Z-purlins (5 degree incline) Load around 1kN per rod What's the best way to attach them? The recommendation is always to hang loads from the purlin web, however many proprietary rod clips hang from the flanges
|
|
|