|
- IAquaLink variable speed schedule - Trouble Free Pool
Thanks so much I will go in and adjust my vsp settings speed 1 to the lowest @ajw22 can you tell me why if I schedule a different schedule name other than filter pump (speed1) the pool temp sensor isn't active? I assume since its the main pump running it is flowing through the temp sensor and the filter etc and acting just the same as "filter
- How to set VSP pump speed schedule in iAqualink?
Hi all New pool owner trying to find my way through the automation system I can't seem to find where I can set the speed schedule in my iAqualink automation I have a Jandy variable speed pump and would D like to run the pump faster at some times of day than others in a schedule automatically
- Communication Loss Hayward - Trouble Free Pool
Still need help getting the VSP to communicate with the HUA (Hayward unique address) With the password I was able to reconfigure my network so my phone app works
- OmniLogic not detecting HUA for Hayward VSP - Trouble Free Pool
I just installed the new Omnilogic Control Panel When I try to configure the VSP, it does not show up in the list of detected devices It appears that the OmniLogic panel is unable to "see" it and therefore unable to obtain it's HUA High voltage wiring is directly to the breaker Low voltage
- Adding Variable Speed Pump to existing Aqualogic automation system
Controls pool, spa and gas heater Ideally, i would like to install a new VS Pump and use as much of my automation system as possible My concern is that the Hayward VSP only work with Software Rev 2 65 and above Is there an upgrade to my existing system, or would i have to replace? If no upgrade, should i go with a 2-speed pump replacement ?
- Hayward OmniLogic Error Message, Variable Speed Pump Not Working - Help!
I also did just install the latest firmware update, and everything was working fine for about a day, but then would not work after We have 2 additional pumps and those (and all other equipment) is working fine The VSP pump is the only one not working
- Jandy and Hayward compatibility - Trouble Free Pool
Q: Will your Hayward PL-PS-4 ProLogic system control (communicate) with my Jandy VSP mod #VSFHP165JEP and my PAL-2000 LED LIGHTING SYSTEM? A: Hi, Gary The JandyFlo VS Pump can communicate with the ProLogic Controller The instructions are located in the Jandy Pro Series VS FloPro™ Series Variable-Speed Pumps Manual
- IAqualink - Setting VSP to different speeds throughout day
Hi- I am struggling with figuring out how to get the pump to switch between different speeds throughout the day For example, high speed for 2 hours in morning, low speed through day, then high speed for 1-2 hours in evening (just an example which I will tweak) I figured out how to adjust
|
|
|