|
- OmniLogic not detecting HUA for Hayward VSP - Trouble Free Pool
I just installed the new Omnilogic Control Panel When I try to configure the VSP, it does not show up in the list of detected devices It appears that the OmniLogic panel is unable to "see" it and therefore unable to obtain it's HUA High voltage wiring is directly to the breaker Low voltage
- IAquaLink variable speed schedule - Trouble Free Pool
Thanks so much I will go in and adjust my vsp settings speed 1 to the lowest @ajw22 can you tell me why if I schedule a different schedule name other than filter pump (speed1) the pool temp sensor isn't active? I assume since its the main pump running it is flowing through the temp sensor and the filter etc and acting just the same as "filter
- Motor replacement on Hayward Ecostar SP3400VSP - Trouble Free Pool
Pool pump is a Hayward Ecostar SP3400VSP Current motor is a single-speed Century 1 25HP (Model HSQ125) I am replacing it with a variable-speed Century
- How to set VSP pump speed schedule in iAqualink?
Hi all New pool owner trying to find my way through the automation system I can't seem to find where I can set the speed schedule in my iAqualink automation I have a Jandy variable speed pump and would D like to run the pump faster at some times of day than others in a schedule automatically
- Communication Loss Hayward - Trouble Free Pool
Still need help getting the VSP to communicate with the HUA (Hayward unique address) With the password I was able to reconfigure my network so my phone app works
- Adding Variable Speed Pump to existing Aqualogic automation system
Controls pool, spa and gas heater Ideally, i would like to install a new VS Pump and use as much of my automation system as possible My concern is that the Hayward VSP only work with Software Rev 2 65 and above Is there an upgrade to my existing system, or would i have to replace? If no upgrade, should i go with a 2-speed pump replacement ?
- Jandy Aqualink RS - Further Reading - Trouble Free Pool
The VSP motor must see a poll before it can respond Once you tell the Aqualink RS that a VSP pump is out there (via the VSP setup page), the Aqualink RS begins polling the motor’s address Century Connect can then see the polling and figure out what system it is attached to
- Hayward OmniLogic Error Message, Variable Speed Pump Not Working - Help!
I also did just install the latest firmware update, and everything was working fine for about a day, but then would not work after We have 2 additional pumps and those (and all other equipment) is working fine The VSP pump is the only one not working
|
|
|