|
- Send Internet Traffic Over WAN 2 Link - Cisco Meraki
Set the primary uplink to WAN2, and then set a SD-WAN policy for VPN traffic with a filter of Any protocol, Any source, and Any destination to use WAN1 and failover if the uplink is down This way the internet traffic will follow the primary uplink (i e WAN2) and the SD-WAN VPN traffic will follow the policy you define Either way should work
- Re: MX85 WAN2 Wont Connect. - The Meraki Community
The WAN2 port has never worked, after some troubleshooting I determined the carriage service is operating fine and the Meraki config is correct We reconnected the service to Meraki and, as before, we see the physical port UP but no layer3 connectivity (Status: Not connected)
- Solved: MX84 with two internet links. One in failed state, but . . .
Hello, I have an MX84, two internet links (100Mbps each) WAN2 shows as Active, WAN1 as failed Both are configured with static IP addresses, and worked when tested with the same addresses from a laptop connected directly to the ISP What is strange, is that a traceroute from the MX will show t
- Enable WAN2 on USG : r Ubiquiti - Reddit
I can't find anywhere to enable WAN2 on the USG I am on v6 0 28 On the LAN page there is a "Add new network" button, but not on the WAN page I have fail over enabled for another USG, so I know it is possible Any ideas?
- Remove UDM-Pro Load Balance WAN Config : r Ubiquiti - Reddit
1 - Under devices edit USG ports and disable Wan2 2 - Under settings edit Networks and delete the WAN2 Network On my case here all ports are configured as DHCP so no more steps than those I mentioned, also I use the classic view on the Controller and not the new one Seems that those steps should work for UDM-Pro too
- MX WAN2 bug (potential PSA) : r meraki - Reddit
Reconnect WAN2 -- everything is still perfect and back to intended state (VoIP phones using WAN1; WAN2 available for failover) I submitted a ticket to Meraki, who advised me to try 16 16 2 So, I started off my morning IN the office this time and the exact same thing happened (I skipped step 2 this time) Hopefully this saves someone some sleep
- Solved: Setting up Secondary WAN - The Meraki Community
A second WAN connection is being added, and while WAN2 is listed as there, I have the dreaded: NOTE: Local WAN configuration cannot be overridden on this firmware version I have been unsuccessful in finding a way to configure WAN2 without flying out or walking someone there through the process of connecting locally (definitely not preferred)
- UDM-Pro enable Port8 as WAN2 : r Ubiquiti - Reddit
I have a UDM-Pro that has Fios as the main internet connected via Port9 Due to some recent issues with Fios, I purchased a Netgear LM1300 to be a backup internet The LM1300 works perfectly if i connect it to Port9, but I would like to have it as an automatic failover instead of manual I also use both SFP as LAN and would prefer to keep it that way So I want to enable WAN2 on Port8 However
|
|
|