|
- verilog - What does always block @ (*) means? - Stack Overflow
The (*) means "build the sensitivity list for me" For example, if you had a statement a = b + c; then you'd want a to change every time either b or c changes In other words, a is "sensitive" to b c So to set this up: always @( b or c ) begin a = b + c; end But imagine you had a large always block that was sensitive to loads of signals Writing the sensitivity list would take ages In fact
- Whats included in a Verilog always @* sensitivity list?
So, always use "always @*" or better yet "always_comb" and forget about the concept of sensitivity lists If the item in the code is evaluated it will trigger the process Simple as that It an item is in an if else, a case, assigned to a variable, or anything else, it will be "evaluated" and thus cause the process to be triggered
- Verilog Always block using (*) symbol - Stack Overflow
The always @(*) syntax was added to the IEEE Verilog Std in 2001 All modern Verilog tools (simulators, synthesis, etc ) support this syntax Here is a quote from the LRM (1800-2009): An incomplete event_expression list of an event control is a common source of bugs in register transfer level (RTL) simulations The implicit event_expression, @*, is a convenient shorthand that eliminates these
- Verilog: Difference between `always` and `always - Stack Overflow
Is there a difference between an always block, and an always @* block?
- Difference among always_ff, always_comb, always_latch and always
I am totally confused among these 4 terms: always_ff, always_comb, always_latch and always How and for what purpose can these be used?
- verilog always, begin and end evaluation - Stack Overflow
The expression always @* begin : name_of_my_combinational_logic_block code end describes combinational logic Typically the clk and rst signals are not read from inside of this type of always block, so they don't appear in the sensitivity list like wisemonkey says It is best practice to use @* for the sensitivity lists of combinational logic so that you don't forget to include a signal
- jQuery ajax () using success, error and complete vs . done (), . fail . . .
The point of the done() fail() always() methods is that you can Attach multiple handlers Do so anywhere and not just when calling $ ajax If you are at the $ ajax call site only attaching single handlers then those advantages don't really come into play So you can return the promise and others may attach their own handlers
- binary - Verilog : Use of assign and always - Stack Overflow
always @ (*) - If something in the RHS of the always block changes,that particular expression is evaluated and assigned Imagine assign as wires and always blocks as registers (For now) , as their behavior is same
|
|
|