companydirectorylist.com  Global Business Directories and Company Directories
Search Business,Company,Industry :


Country Lists
USA Company Directories
Canada Business Lists
Australia Business Directories
France Company Lists
Italy Company Lists
Spain Company Directories
Switzerland Business Lists
Austria Company Directories
Belgium Business Directories
Hong Kong Company Lists
China Business Lists
Taiwan Company Lists
United Arab Emirates Company Directories


Industry Catalogs
USA Industry Directories














  • Your Guide to EXTREMELY common problems with an XJ (and how to fix . . .
    Cause: Broken wire leading to the speaker As you've already seen twice in this thread, broken wires in the door jambs are VERY common and usually the #1 source of electrical issues in XJ's The constant opening and closing of the doors bends the wires back and forth, and Chrysler used really cheap grade wires, so eventually they break apart
  • Jeep Cherokee XJ 1984 to 2001 How to Replace Crankshaft Position Sensor
    This article applies to the Jeep Cherokee XJ (1984-2001) The crankshaft position sensor (CPS) is a common cause of stalling in the Jeep Cherokee If the PCM fails to receive a signal from the sensor, it automatically shuts off the engine The CPS can fail due to corrosion, or general wear and tear Replacing the sensor should be simple right?
  • Jeep Cherokee Forum
    Stock XJ Cherokee Tech All XJ Non-modified stock questions go here; Modified XJ Cherokee Tech; MJ Comanche Tech Stock Modified KL Cherokee Tech; Modified Grand Cherokee Tech All ZJ,WJ WK aftermarket tech goes here; Stock Grand Cherokee Tech All ZJ WJ WK Non-modified stock questions go here! Fabrication builders section Jeep Builds
  • Jeep Cherokee 1984-2001: Transmission and Gear Ratio Information
    This article applies to the Jeep Cherokee XJ (1984-2001) Automaker's engineers look at the vehicle in whole to match the best gearing in the differential to the transmission gearing, the torque as well as horsepower of the engine, the tire diameter, and the weight of the vehicle
  • The Official SYE (Slip Yoke Eliminator) Thread *All Read*
    When lifting an XJ, the angle between the rear axle pinion and the slip yoke become much greater The factory setup was not intended for these variations in lift The angle difference will be most noticeable in the fact the slip yoke will be pulled further out of the housing than before the lift
  • Jeep Cherokee 1997-2001: Why is the A C Not Working?
    This article applies to the Jeep Cherokee XJ (1997-2001) Is your air conditioning (A C) working properly? A working A C in the Jeep Cherokee is a relief on a hot day However, there are quite a lot of components in the A C system that can break over the years
  • Jeep Cherokee XJ 1984 to 2001 How to Replace Serpentine Belt
    For early XJ models, it is best to remove the airbox assembly for easier access to the power steering tensioner bolts (refer to article How to Make and Install Cold Air Intake for airbox removal) With the airbox removed, loosen the (2) power steering pump bracket bolts from the backside of the pump with a 13mm wrench
  • Wiring Diagrams!!!!!!!! - Jeep Cherokee Forum
    Stock XJ Cherokee Tech All XJ Non-modified stock questions go here; Modified XJ Cherokee Tech; MJ Comanche Tech Stock Modified KL Cherokee Tech; Modified Grand Cherokee Tech All ZJ,WJ WK aftermarket tech goes here; Stock Grand Cherokee Tech All ZJ WJ WK Non-modified stock questions go here! Fabrication builders section Jeep Builds




Business Directories,Company Directories
Business Directories,Company Directories copyright ©2005-2012 
disclaimer