|
- Yugo M70 and M72 (RPK) receivers - whats the diff?
Yugo M70 and M72 (RPK) receivers - what's the diff? Been doing some research on these Yugo receivers and I am finding conflicting information I always heard people say the Yugo AKs were better built because of the 1 5mm receiver, then more than not they would say it was an RPK receiver
- [Want To Sell Trade] Yugo M57 Tokarev C R Eligible [York, PA]
Yugo M57 Tokarev pistol chambered in 7 62x25 PW Arms Redman WA import marks $300 OBO C R holders: Transfer FTF with copy of your 03FFL for my bound book records
- [CLOSED] WTT WTS - Gewher98M, Yugo SKS 59 66 Price Drop
Similar Threads WTT Yugo fixed stock for Yugo underfolder By S45 in forum General Replies: 0 Last Post: August 14th, 2009, 08:38 PM
- Yugo M48 no crest - Pennsylvania Firearm Owners Association
Re: Yugo M48 no crest There are three main versions of the M48 M48: 1948-1952 - The initial version of the M48, with full crest and all machined steel parts M48A: 1952-1956 - Inclusion of stamped parts the M48A used sheet metal stampings for the magazine floor plate These changes sped production while lowering cost
- Review: Zastava M83 Revolver . 357 Magnum
Sorry for the Necrothread revival, but I was wondering if anyone could give some advice about what holster would be a good fit for this revolver I still have it but have never carried it, and I'm thinking of doing so for going out in the woods hunting as a carry piece since its 357 Mag, rather than the 45 I usually take ZASTAVA1 JPG Anyone care to take a guesstimate of what size S W
- Adjusting the front site on a yugo m57 tokarev
It appears that my yugo m57 tokarev shoots low The front site appears to be a bit on the high side Are these difficult to adjust if they are adjustable at all? I was able to have some success with having the front site above the rear site (it has very "rifle looking" iron sights) when lining them up, which is what I figure I'll have to do for this gun
- Differences between German K98 and Yugo 24 47?
The Yugo surrounds the rear sight and goes to the front of the receiver The K98 has a shorter handguard that starts at the front of the rear sight Typically the 24 47 has a straight bolt and the K98 is bent The 24 47 has a so called "safety ring" at the breech of the barrel that the typical 98 action does not have
- Stumped trying to remove SKS hammer
Stumped trying to remove SKS hammer My Yugo SKS has a hammer spring reported to be rated at 34 pounds After polishing the easily removed sear and reducing its spring weight a little, I coaxed the 7 pound trigger down to 6 25 pounds A 27 5 pound hammer spring arrives tomorrow I also have a new hammer and sear on order
|
|
|