Need Help - Graphtec Not Cutting in some areas deep enough but can cut . . . I am having an issue with my Graphtec FC-9000-140 It is cutting them deep enough in some spots However, some areas are not deep enough when cutting out on the same job The blade force is set at max and the depth is very deep and cut all the way through the vinyl a few times The top knob has
Perfect settings for Graphtec - Signs101. com: Largest Forum for . . . I've got the new Graphtec FC8000 series (64") It came with a firmware glitch, but I've gottent hat sorted out fine now, and it cuts beautifully It's very much noisier (makes a loud rattling noise even though I checked to see if the blade was tight) than my other plotters though, and I was
Graphtec FC9000-140 over TCP IP Cannot open port. (fixed) I'm having a problem that started suddenly out of nowhere this morning We have all our cutters connected to Flexi Production Manager via the network All cutters have DHCP turned off with manually set IP subnet gateway We have two FC9000-140 cutters side-by-side, both new (about 2 months old
Graphtec plotter - Cant Open Port error - Signs101. com: Largest . . . Graphtec tech support just called Said USB port is likely shot on plotter and you need to use Graphtec-specific serial cable that has different pin layout from standard serial cable Of course, they no longer sell them He sent me a diagram of the pin layout but there's no way I'm soldering those hair-thin wires
Plotter Confusion - Summa or Graphtec - Signs101. com: Largest Forum for . . . The Graphtec FC machines do have more cutting force than the drag knife Summa models (600 grams on the FC8600 400 grams on the S2 D Series), but they only offer accurate contour cuts up to 80" so for contour cutting applications they aren't nearly as good