|
- Mini 3 Pro - Replacing rear motor without opening a drone
Hello I need to replace both rear motors I don't want to disassembly whole drone, so I'm thinking about pulling out the motor from the arm, cut the wires and solder new motor I know this is possible, because I pulled my motor out, but I'm worried about antenna and it's signal wire, because
- replacing an absolete component of converter | Electronics Forum . . .
Hello, the DB02S4815A got instict completely,I cant order it no where I found JWE0848S15 this DC-DC type is much bulkier ,if we look at lm137 its a much much smaller DB02S4815A and JWE0848S15 are much bulkier I know that they both input 48V and output 15V , what else is in common between the
- Gimbal screws and replacing bracket on - DJI Mavic, Air Mini Drone . . .
I have put back together the entire gimbal already, and I would much rather superglue a plastic piece to the motor than fully disassembling the gimbal again and replacing the motor entirely I am also looking for replacement Philips 1 screws for the gimbal internals does anyone have the specs on the screws?
- DJI Mini 4 Pro Vision Sensor Calibration After Crash
Just by replacing vision sensors It will not work Professional calibration by specific tool is required Contact any drone repair or service in your area I just wait, official calibration software support to change it Like it is done in Mini 3 Pro We will see
- Replacing MOSFET, what to look for | Electronics Forum (Circuits . . .
Hello forum, I'm replacing the MOSFETs in an Electronic Speed Control (ESC) for RC cars My problem is, I don't really know what to look for when choosing the new MOSFET The current rating of my MOSFETs are all higher than the old ones in the ESC I'm more interested in the gate charge
- DJI Mavic, Air and Mini Drones - DJI Mavic, Air Mini Drone Community
After replacing the mavic 3 classic vision sensor module with a new one It says “error sensor vision” and the drone does not take off Any suggestions? DJi
- DJI Mavic, Air and Mini Drones - DJI Mavic, Air Mini Drone Community
Repair Service: Replacing the LR arm axis was honestly a relatively easy repair After replacing the arm, and powering up the gimbal does its vertical and horizontal tests, but the roll motor "snaps" to ~-45* offset and doesn't move The roll motor "buzzes" lightly and stays engaged, providing resistance to the touch
- Replacing the gimbal cable (not the gimbal camera unit ribbon)
Taking off the gimbal bridge cable is the easy part Stripping down the gimbal is the hard part I have done many You have to thread the broken cable down through the hole in the gimbal motor assembly, remove all 3 glued motor covers with a heat gun, remove the camera barrel from the gimbal motor assembly, and replace the LVDS ribbon cable
|
|
|