|
- LS Swap tranny fluid lines - Team Chevelle
LS Swap tranny fluid lines Jump to Latest 4 2K views 4 replies 5 participants last post by Blackhawk Dec 22, 2020 proj4ever Discussion starter
- How much fluid for a TH-400 - Team Chevelle
Here is an easy one My tranny gasket was about gone so I replaced it I dropped the pan, changed the filter and gasket and then replaced the pan I put four qaurts Dextron Mercron III tranny fluid into it Started motor, let it get hot, shifted through all gears and checked the fluid level
- The Best Tranny TH400 Re-Build Kit?? | Team Chevelle
I'm about 2 weeks away from dropping a 500hp 454 in my '70 elky and I have concerns about the tranny holding up under the new power plant Is a rebuild in order? Which kit is the best I'm considering the Hughes, TCI, and B M kits Or is there a better option out there? Thx
- Pilot bushing and Muncie Tranny - Team Chevelle
The tranny is marked as: on case - GM patent # 3088336 then 7-1, then P R07 On slider shift cover plate - 3884685, on the spline input shaft housing - GM14 and 38 (or 9)15020 The tranny case to the end of the input shaft measure 6-9 16" The pilot section in the bushing is 1 750" - 1 800" long, The 10 spline end is 2 350"
- th350 kickdown cable hole leak - Team Chevelle
I replaced the little rubber boot gasket at base of kick down cable at tranny, put a bit of fluid, ran it for a bit and slowly but surely began leaking again Not as much a prior to replacing the boot I tightened the bolt nice and tight By chance, does the bolt need some type of sealer? Is it
- What size tranny cooler to use - Team Chevelle
What size tranny cooler to use ? Jump to Latest 7K views 10 replies 9 participants last post by Bbbad1 Jan 23, 2019 B
- Borg Warner Super T-10 decode help - Team Chevelle
On the main case: B 3 77, G5, 13-04-097-901 On the tail section 13-04-066-903 Speedo cable on Pass side with 13 04 065 903, W G Div ,FpC2, 27N130391 These are exactly as inscribed on tranny Can anyone decipher? Thanks, Roland "some people spend their entire life trying to make a difference, US MARINES don't have that problem" Ronald Reagan
- Cant get tranny splines to line up with clutch disc splines. . .
Well after putting in the new clutch and bellhousing I tried to get the transmission in with absolutely no luck I thought that things weren't aligned correctly and the input shaft was hitting the pilot bushing Well I take the bellhousing off and re-align the clutch disc with a clutch
|
|
|