copy and paste this google map to your website or blog!
Press copy button and paste into your blog or website.
(Please switch to 'HTML' mode when posting into your blog. Examples: WordPress Example, Blogger Example)
Input Form:Deal with this potential dealer,buyer,seller,supplier,manufacturer,exporter,importer
(Any information to deal,buy, sell, quote for products or service)
Do I need 4x4 to launch boat? - iboats Boating Forums Re: Do I need 4x4 to lauanch boat? Re: Do I need 4x4 to lauanch boat? Sounds to me like you'd be fine with either your F-250 V-10 or the dually, but like Bob said, a lot can depend on the ramp conditions, angles, etc Some of our tidal ramps down south can get a growth of algae slime or pluff mud on them making them so slick you can't even stand up on them I pull my boat with a Buick
Boat taking on water | Boating Forum - iboats Boating Forums Re: Boat taking on water Have you ran it and looked at all hoses etc? If it's not bellows, and it takes on water while on muffs, it certainly sounds like an engine cooling system issue Hose, manifold (s), thermostat housing, fuel cooler (not sure on 4 3) etc I think I'll move this to the Merc I O section Not sure how water entering hull on muffs could not be engine drive related This
Spray Can Foam for Flotation? - iboats Boating Forums Re: Spray Can Foam for Flotation? Hello jarway i just redid my boat and did a butload of looking and asking about foam what are the dimentions you are tring to fill , some of the spray can foam is polyurathane "great stuff is one"at home depot and is closed cell ,atrick to getting aplication and max volume is to warm can in water for 5-10 min just before using , any thing bigger than a
Whats new | Boating Forum - iboats Boating Forums Need help with ID of what's left of an 18' alum boat Captain Davie Thursday at 11:40 AM Boat Restoration, Building, and Hull Repair Replies 11 Views 324 10 minutes ago
Best way to remove old boat stripes decals? - iboats Boating Forums Re: Best way to remove old boat stripes decals? Great question! My anchor rope tore up a pin stripe on the bow after being anchored, and I was wondering how to remove that stripe too Will the WD-40 hurt the gelcoat?
Aluminum Boat Transom Repair - iboats Boating Forums Re: Aluminum Boat Transom Repair Wow, this is a new and different challenge! Yah, like grub mentioned, a shot of what ya got on the inside would be really helpful Welcome to iboats
What are my best options for covering bunks? - iboats Boating Forums Re: What are my best options for covering bunks? If you have a fiberglass boat, use regular bunk carpet - your indoor outdoor carpet may work, but you would need to investigate it more If you have an aluminum boat, avoid carpet altogether (leads to corrosion) and use the plastic strips