copy and paste this google map to your website or blog!
Press copy button and paste into your blog or website.
(Please switch to 'HTML' mode when posting into your blog. Examples: WordPress Example, Blogger Example)
how do i test the orange wire??? - Blue Traxx Forum The CDI box is sending its 12V pulse to the coil, as it should, but the coil is unable to properly transform it Nothing, or an inconsistent blink of the test light, indicates that your ignition coil is not recieving its proper trigger pulse from the other components of the bike's ignition system
Cdi wiring help - Blue Traxx Forum Hi back again sorry for taking so long to update this thread 😀 I recently received a new CDI and stator for 90-95 and installed both parts and still no fire plugged the four wire stator plug into the CDI box and the left the three white wires disconnected from stator to voltage regulator rectifier also there is two plugs coming from CDI I
Stator pickup coil testing by RickyStator | Blue Traxx Forum Hi, Just got an email from Ricky Stator about how to test your stator pickup coil: "You can do an OHMS reading on your stator and pick-up if you have a multi-meter OHMS meter Make sure your meter is set at the 2K setting Brown to Green wire should read 275 ohms (source coil) Red to White
Yamaha Timberwolf 250 2x4 no spark | Blue Traxx Forum Disconnect the CDI Magneto coupler Using the Yamaha pocket tester (set at Ohms x100) measure impedance between black (-) and brown (+) wires 428-523 Ohms at 68 degrees F is the spec To test the pickup coil Disconnect the CDI Magneto coupler
CDI Issue - Blue Traxx Forum source generates the spark energy, which is sent to the cdi and stored the pulse coil sends a signal to the cdi as to when to dump the charge from the cdi, the charge goes to your ignition coil, where it gets ramped up and shot through the spark plug the ignition switch and or bar switch either ground out the cdi, or they complete the
Have spark but still will not start - Blue Traxx Forum 2000 warrior that I replaced both the stator and cdi to get spark and all seems good in the spark department now I bought it used from a guy who had just replaced the cylinder base gasket and it had not run since Valve clearances seem right Valve timing looked like it was about 1 2 tooth
89 Yamaha Big Bear 350 ignition help | Blue Traxx Forum Looks like one of them would have advance-timing, as another magnet is spaced about 1 5" further around The source coil is responsible for generating the voltage for the CDI to create the low-side voltage to the ignition coil, and the charging coil feeds the regulator which, well, charges the battery, feeds the lights, and accessories