copy and paste this google map to your website or blog!
Press copy button and paste into your blog or website.
(Please switch to 'HTML' mode when posting into your blog. Examples: WordPress Example, Blogger Example)
Input Form:Deal with this potential dealer,buyer,seller,supplier,manufacturer,exporter,importer
(Any information to deal,buy, sell, quote for products or service)
Flashforge Adventurer 5M enclosure by ffontana - Thingiverse Complete enclosure as tiny as possible and with multiple opening options I didn't like the official enclosure as I think makes the printer very big and has some kind of a toy appearance Original metal frame at sight (not bigger than de original frame) Front door can be left hand o right hand with hidden hinges (have to mirror some pieces) Upper window has multiple opening options also with
AD5X Spool Adapter by rodder - Thingiverse This adapter is for the Flashforge AD5X The spool holders are great for smaller spool hub diameters - not so much for the larger ones Sunlu Jayo, for example, have a 73mm diameter hub hole, and the AD5X spool holder will not grab it and provide tension
AD5X Partial enclosure by Arnookie - Thingiverse Flashforge Adventurer 5x AD5X Partial enclosureThis will at least let you install the front door, I used acrylic panels attached directly to the sides, Still open topped but works ok
(New version) Flashforge Adventure 5M Spool Holder - Thingiverse This is a spool holder for the Flashforge Adenturer 5M because the spool holder it comes with it awful and doesn't even keep the spool from sliding off This is an update on my previous design for this holder The spool holding part is shifted 4cm or so to the side to reduce the stress on filament from spools that are close to empty I'm publishing it separately since the other one still works
Flashforge AD5X Poop Shoot slide right side discharge I got tired of pulling my FlashForge AD5X out every time I needed to clean up the purge waste that collects behind it So I designed this simple chute to redirect all that junk out the right side, near the filament spools The model prints in two parts:The base mounts using the factory bolt holes—no permanent modifications needed I recommend adding a bit of double-sided tape to help keep it