copy and paste this google map to your website or blog!
Press copy button and paste into your blog or website.
(Please switch to 'HTML' mode when posting into your blog. Examples: WordPress Example, Blogger Example)
Input Form:Deal with this potential dealer,buyer,seller,supplier,manufacturer,exporter,importer
(Any information to deal,buy, sell, quote for products or service)
D784-1 Installation Instruction Step 7: Bleed your brake system according to the owner’s manual Add Galfer DOT-4 brake fluid to the system and build appropriate pressure
Microsoft Word - D195 INSTALLATION PROCESS. doc - Galfer USA Remove the stock hoses on the front of the motorcycle, and replace with Galfer hoses labeled A,B,C,D,E,F,G Locate lines A this hose will run from the master cylinder down to the right caliper and across the fender through the C-CLIP down to the left caliper
Microsoft Word - D419SB REV 2 Instructions. doc Step 4: Install the Galfer male adapters onto each caliper These adapters thread to the caliper using one (1) washer Torque level is 12 to 13 ft pounds
Microsoft Word - D700SB REV 2 Instructions. doc Install the Galfer male adapters onto the right and left calipers Thread each adapter with one (1) washer into the calipers (refer to picture E,) and torque at 12 - 13 ft pounds
Microsoft Word - d15cl. doc - Galfer USA Step 7: Bleed your brake system according to the owner’s manual Add Galfer DOT-4 brake fluid to the system and build appropriate pressure
Tuesday, June 25, 2002 All Galfer fittings are what we refer to as turn-to-fit and can be rotated to alleviate twist or tension in the lines To do so, firmly hold the crimped portion of the line; insert a wood dowel, brass punch, or pen into the banjo, and rotate as shown in the diagram below
Tuesday, June 25, 2002 - galferusa. com All Galfer fittings are what we refer to as turn-to-fit and can be rotated to alleviate twist or tension in the lines To do so, firmly hold the crimped portion of the line; insert a wood dowel, brass punch, or pen into the banjo, and rotate as shown in the diagram below
Microsoft Word - D694-6 Instructions. doc Familiarize yourself with the new Galfer brake lines; notice that each line is labeled for application Lines A, B and C will be installed on the front end of the bike, Line D will install from the Clutch master cylinder to the slave cylinder and Lines E and F will be used for the rear application
Microsoft Word - D773-2 Instructions. doc Use the Galfer provided c-clip and OEM bolt to retain the two (2) lines to the stock mounting point at the lower triple tree Continue to route the lines behind the forks and down to the right and left caliper
Microsoft Word - D622-1. doc Step 7: Bleed your brake system according to the owner’s manual Add Galfer DOT-4 brake fluid to the system and build appropriate pressure