copy and paste this google map to your website or blog!
Press copy button and paste into your blog or website.
(Please switch to 'HTML' mode when posting into your blog. Examples: WordPress Example, Blogger Example)
Input Form:Deal with this potential dealer,buyer,seller,supplier,manufacturer,exporter,importer
(Any information to deal,buy, sell, quote for products or service)
Troubleshooting ECU drivers and the ISC - GalantVR4. org I'll test the ISC tomorrow to confirm it's bad, but suffice it to say something bad happened and completely fried the ISC driver The ECU seemed fine up until recently, when I installed the WB I mentioned this to Thomas, who seemed to think the WB install couldn't have caused the issue That was a relief
Lets talk FIAV and ISC block off plates! - GalantVR4. org The ISC did just fine, though as stated already - took a few more cranks and sometimes a second of throttle to get it idling normally Btw, 3 out of 4 adjusters were easy as pie to adjust down the runt of the litter was a B*tch! Blow torch and all it took like an hour and a half to get it all of the way down
Setting BISS and ISC Range - GalantVR4. org You want the ISC in the middle of it's range, while adjusting the BISS for optimal setting (Our idle should be 800 RPMs) But what exactly is the middle of it's range? If you log it, I think it goes anywhere from 0-100+ Does anybody have hard evidence on where it should properly be set @ idle with a logger using MMCD?
ISC replacement options. - GalantVR4. org Seems the ISC driver kursploded from a short, which explains why it was unplugged The OEM replacement seems to be big money Has anyone had any luck with the one offered by Rock Auto? Are there better options I'm not finding? I have yet to OHM mine out but with the motor unplugged and the damage I'd say there's a good chance it's bad
What throttle body for GVR4? - GalantVR4. org Yes newbie question here What other throttle body will mate to GVR4 I am looking to get one locally to remove the isc and plug the coolant line Would N T throttle work ok? or not because of the TB elbow? detail list would be greatly appreciated
What is Proper ISC Voltage and where to check? - galantvr4. org Have you pulled your ISC and make sure it moved like in the youtube video I keep linking on Tuners? After bootim the ECU homes the ISC by stepping it all the way out, then back to 0, before moving to the position for starting the car Remember that idle surge is caused generally caused by too much air bypassing the closed throttle plate
ISC clamp - galantvr4. org If the ISC can't react fast enough, it won't catch them in time It might not be as difficult as you think to tap a nipple into the FAIV to port air into it from pre-compressor You would just then have to block off the port on the TB that normally supplies air to the ISC