copy and paste this google map to your website or blog!
Press copy button and paste into your blog or website.
(Please switch to 'HTML' mode when posting into your blog. Examples: WordPress Example, Blogger Example)
Input Form:Deal with this potential dealer,buyer,seller,supplier,manufacturer,exporter,importer
(Any information to deal,buy, sell, quote for products or service)
Jeep Enthusiast Forums A community for Jeep owners and enthusiasts to discuss performance, modifications, and more
Write-up: PCM alternator voltage regulator bypass As we all know, Mopar truck SBEC JTEC JTEC+ and probably all the newer engine power control modules use an internal voltage regulator located in the control module for the alternator When it fails, the ECM PCM should be replaced The OEM setup is a good setup in a way; it uses battery
CAD File Sharing Now Possible!! | Jeep Enthusiast Forums Had a few folks ask about sharing CAD Files here on the forum I asked Philip about it and he made it happen!! So we can now attach the following File Types to a Post and they should be able to be downloaded by fellow members The Following Files can be Uploaded: pdf dxf dwg ipt
Jeep WJ Ground Write-up Info | Jeep Enthusiast Forums The WJ electronics require good clean grounds to avoid electronic failure or creating havoc The purpose of this thread is to pinpoint ground locations along with listing which components connect to each ground In addition to insulated ground wires, flat ground straps will also be included
No Power to TCM Reason for No Shifting? - Jeep Enthusiast Forums Finally got it the above response was the right answer for my 93 zj Try running power to pin F-16 Simply no power going to the TCM I pulled it out and it looked like it was new Ran a jumper and it works just like new again Now I'm going to run a more legitimate solution and splice the wire into something that is Switched by the ignition Thanks again for all your helps!
Oxygen Sensors (more info than you probably want) I have been collecting O2 sensor info over the years Half of the following is in my own words so feel free to correct anything you see wrong The O2 sensor is there primarily because of emissions! A second reason is to fine tune fuel management And thirdly they indicate the state of the
Control Arm Length Chart - Jeep Enthusiast Forums Gonna be buying Adjustables soon And I know this info would be good to have fresh in the forums So if anyone has a chart that shows the recommended control arm lengths for various lift heights, that would be awesome
How to check TCM - Jeep Enthusiast Forums Yesterday my 42RE started to show some problem: a) no 1st b) no shift at all (2nd, 3rd and reverse are there when I move the lever) c) no overdrive The overdrive switch LED does not light, no codes, nothing So I suspect that the TCM is either dead or somehow disconnected I checked all three
LSX Swapped WJ - Jeep Enthusiast Forums Anyone done it on here? I have an 01 Camaro that's my race car Recently added a cutout to my WJ it's just making me miss the power even more from my Camaro I was thinking about adding LT headers to my 4 7 but those are ridiculous on pricing Cost more then my cam headers for my Camaro! The