copy and paste this google map to your website or blog!
Press copy button and paste into your blog or website.
(Please switch to 'HTML' mode when posting into your blog. Examples: WordPress Example, Blogger Example)
Input Form:Deal with this potential dealer,buyer,seller,supplier,manufacturer,exporter,importer
(Any information to deal,buy, sell, quote for products or service)
Erickson Quick Change 30 Tooling And Sources Resource. The large names like Kennametal, Collis, Briney, Lyndex, etc carry them but cost is prohibitive for a Personal machine shop Erickson quick Change still has a strong following throughout the U K and Europe
Kennametal Top Notch - The Hobby-Machinist I bought right and left Top Notch insert holders at my local flea market a few years ago after seeing a Top Notch threading tool used on Joe Pie's channel That video series resulted in a happy coincidence that I'll explain later My flea market source had some Kennametal threading inserts in
Kennemetal Top Notch holder question | The Hobby-Machinist Question Do the Kennemetal Top Notch inserts fit other brands of tool holders, or no? Inserts are cheap and all over eBay, so are a more attractive option than ThinBit and other brands where the inserts are less common and not many deals seem to be available Thanks in advance
Kennametal Top Notch boring bar | The Hobby-Machinist Looking for a Kennametal A16NER3 stock number 1094835Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
Using 1 2 tool holder in an AXA tool post. - The Hobby-Machinist I figured since my tool post would hold 1 2" holders, they would be more rigid and give me more options I purchased a Kennametal and placed in the tool post, even at the lowest adjustment, it was slightly above center I ended up putting the tool holder in the mill and shaving a couple mm's off the bottom side and it worked out
ERICKSON TENTHSET Boring Head tear down? | The Hobby-Machinist Kennametal tenthset boring head, disassembley and cleaning help Hi folks, I recently purchased at auction a lot of Kennametal tenthset heads, four of the larger #50's and one of the smaller #37's These are the type with the collar on the outside that rotates around the head to set size, not the screw dial type like a Bridgeport boring head
Brands of indexable tool holders. | The Hobby-Machinist Is there much difference between different brands of the same tool holder? For example an MCLNR, is there much difference between say Kennametal, Iscar, Dorian, Hertel, Sumitomo, etc ?
Kennametal Replacement Parts? | Page 3 | The Hobby-Machinist Here is an example of the shim I had to find As Matt said, these are pretty specialized screws as well The shim seat screw is hollow and then carbide cutter screw is solid This is the screw that holds the cutting insert: