copy and paste this google map to your website or blog!
Press copy button and paste into your blog or website.
(Please switch to 'HTML' mode when posting into your blog. Examples: WordPress Example, Blogger Example)
Input Form:Deal with this potential dealer,buyer,seller,supplier,manufacturer,exporter,importer
(Any information to deal,buy, sell, quote for products or service)
SVI autostate - Cisco Learning Network You would only need a single trunk link for all the SVI's you want, as long as you're not pruning VLANs from the trunk SVI's in this regard are a bit less convenient to use than a loopback interface that you could use on a router
Solved: vlan svi-- line protocol is down, why? - Cisco Community When configuring SVIs, you can use the switchport autostate exclude command on a port to exclude that port from being included in determining SVI line-state To disable autostate on the SVI, use the no autostate command on the SVI
SVI Autostate - routerjockey Switch Virtual Interfaces, or SVIs on Cisco IOS use a feature called autostate to determine the interface availability
Configuring Layer 3 Interfaces - Cisco Similarly, the SVI interface goes “down” when the last STP forwarding port goes down or to any other state This characteristic of SVI is called 'Autostate' You can create SVIs to define Layer 2 or Layer 3 boundaries on VLANs, or use the SVI interface to manage devices
CISCO-SVI-AUTOSTATE-MIB - Observium The MIB module is for configuration of the switch virtual interface (SVI) autostate feature Autostate feature is a mechanism to calculate the state of a SVI dynamically when some condition occurs such as a failure of a participating interface in that SVI
Configuring SVI Autostate Exclude - Cisco Nexus 3000 and 9000 Series NX . . . You can configure the SVI Autostate Exclude feature on an Ethernet interface or a port channel You can use the Autostate Exclude option to enable or disable the port from bringing up or down the SVI calculation and applying it to all VLANs that are enabled on the selected port
Solved: Vlan UP line protocol Down - Cisco Community It is because of Autostate is implemented on CatOS and IOS Cisco based switches by default On some CatOS platforms, this feature can be disabled in order to allow redundancy in special scenarios On IOS based switches, this feature cannot be disabled
Switching - switchport autostate command - NetworkLessons Notes There are three requirements for an SVI to be in a state of up up: The VLAN must exist and be active in the VLAN database At least one interface should be active for the VLAN That interface has to be in Spanning Tree Protocol (STP) forwarding state